Aluminum Molten Filtering Units

Aluminum Molten Filtering Units

Online Plate type Filtering Unit is used for the filtering and purifying of the molten aluminum, matching with the ceramic foam filter. It can filter the inclusions and tiny particles in the molten aluminum. Especially suit for the casting high purity aluminum and high precision aluminum alloy. It has the advantages with thermal resistance, anti-oxidation, corrosion resistance, warming up quickly, long lifetime and acid resistance.

Properties:

It is made of the high purity silicon carbide material. The normal service temperature is 1450℃, it can be used continuously for 2200 hours. Features thermal resistance, anti-oxidation, corrosion resistance, warming up quickly, long life time and acid resistance.

The casing is welded by the steel plate and adopted to the advanced rust removal process and corrosion-resistance coating.

With lifting and rotating device, small size, high accuracy, complete synchronization, good self-locking performance, stable structure.

The lining is made of high silicon melting material. Non-stick aluminum, high corrosion resistance, can prolong the life time.

With reasonable design and high absorbed ceramic foam filter.

ASSEMBLES

  • Mechanical Device
  • Tank Body and Cover
  • Heater
  • Electric Controller

Standard sizes:

15in, 17in, 20in, 23in, 26in;

Primary Filtration / Two Stage Filtration

The lining is made of high silicon melting material. Non-stick aluminum, high corrosion resistance

Instructions:

Install filter box in steel casing according to the drawing.

Put insulation board at the bottom and sides of steel casing and then install the filter box properly.

Keep the filter box lining clean, no damage and no gap.

Preheating the installed filter box properly, use electric heating or gas flame heating , avoid direct fire contact box wall. Maximum temperature is within 850℃ to remove the adsorption of crystal water. Make sure safety and efficiency.